Quality Control
Industrial minerals as never before
The company has well equipped laboratory cum research development unit where chemical and physical analysis of the mineral is carried out, bulk density, retention/residue on required mesh size or micron size, specific gravity, oil absorption, loss on ignition, moisture contents, chemical contents, hardness, brightness, whiteness ,particle size analysis are also analyzed by experienced chemists with highly sophisticated equipments. We are very strict in maintaining the quality as per customers requirements and their specifications. We have very good quality control systems and equipments used and supervised by experienced and qualified chemists and lab assistants.

We have following equipments and apparatus to test the different chemical and physical specifications:
  1. Reflectance Meter: To test Whiteness & Brightness of the powder.
  2. Balance: To weigh the powder with accuracy.
  3. Sieves: To test the fine ness of powder from 100 mesh to 700 mesh sizes.
  4. Oven: for burning and fusing of the powder and crude both up to 300.
  5. Furnace: for burning and fusing of the powder and crude both up to 1200.
  6. Hot Plate: To boil the solutions.
  7. Vacuum pump: for filtration of insoluble/ soluble matter.
  8. Volumetric Cylinders: to test the bulk density (B.D.) of the powder.
  9. Burette: for filtration of powder solution to test fe2o3, CaC03, Al203 etc.
  10. Pipette: for titrations of powder solutions to test the chemical analysis.
  11. VM flasks: to measure the powder solutions as per standards.
  12. Other apparatus: platinum crucibles, silica crucibles, Beakers, test tubes, flasks, etc. and so many other tools and apparatus required.
  13. Chemicals: viz.; HCL, Sulphuric Acid, Nitric Acid, Caustic, Ammonium, PDTA, KMNO 4, K2CrO 7, chloride, etc. and all other chemicals as per requirements.
 
All Copyright © Shri Kailash Khanij Udhyog. All Rights Reserved.
Best Viewed in 1024 X 768 or above resolution & IE 5.0 or later version